Good deal Mike. This is a big deal in my book Mike and just what our League should be pursuing. I do have an IC-7610, BTW. I doubt they are not already clean as a whistle, but improvement is always worthwhile. And then there are some contest stations that prefer to be, well, wider to keep “their” frequency clear on both sides. How we deal with that is a question for the future. Bob Famiglio, K3RF ARRL Atlantic Division Director 610-359-7300 www.QRZ.com/db/K3RF From: arrl-odv <arrl-odv-bounces@reflector.arrl.org> On Behalf Of Mike Ritz Sent: Monday, November 27, 2023 12:02 PM To: arrl-odv@reflector.arrl.org Subject: [arrl-odv:35362] Fwd: Icom "Dynamic Predistortion" Changes to IC-7610 Some positive news. (See below.) I’d like to think this is a result of ARRL’s CSI efforts! It does show that manufacturers are taking the effort seriously though, and that ARRL can make an impact in the technical space as a benefit for members. Lots of bad clicks and chirpy signals in the CW test last weekend, including one from EU that sounded like an old spark set! Hope everybody had a great Thanksgiving. 73; Mike W7VO Sent from my iPhone, utilizing a very tiny keyboard fed from very fat fingers Begin forwarded message: From: Mike Ritz <w7vo@comcast.net<mailto:w7vo@comcast.net>> Date: November 27, 2023 at 8:40:31 AM PST To: Alan Rovner <k7ar@comcast.net<mailto:k7ar@comcast.net>> Subject: Re: Icom "Dynamic Predistortion" Changes to IC-7610 Thanks, Al! Another ham sent me a note on this also. Icom is one of the JA manufacturers involved with the CSI. Ray Novak, N9JA is a committee member. I don’t know if this was a direct result of CSI, but I’d like to think so! This is exactly what we were hoping would happen. 73; Mike W7VO Sent from my iPhone, utilizing a very tiny keyboard fed from very fat fingers On Nov 27, 2023, at 8:14 AM, Alan Rovner <k7ar@comcast.net<mailto:k7ar@comcast.net>> wrote: Hi Mike I thought you might be interested this news as part of your Clean Signal Initiative. Icom has released new firmware for the IC-7610 that implements something called dynamic predistortion. As far as I can tell it generates a cleaner SSB signal when enabled. I'll include a photo below. While this is a good thing, it looks like it only works with their upcoming PW2 amplifier. There is ongoing discussion about whether non-Icom amps will be supported. Also this only applies to normal SSB voice signals. CW, RTTY, FT8 or other audio tone modes have no need for this feature. In order to use predistortion, you have to connect the 7610 to a dummy load and go through a calibration process for each band. In the photo below the blue graph represents energy without predistortiion and the pink graph shows a cleaner signal with predistortion. Notice the pink graph has less energy away from the center test tone. Thought you might be interested, 73, Al, K7AR <FLgMmPe5ca0PzGmI.png>